How to Use Brush On Block®
Brush On Block is housed in a self-dispensing brush. When you open the brush, the powder flows through a channel inside the brush and out the head of the brush. Check out our short video explainer to see how it works!
Get to Know Your Brush
- Cap - keeps your bristles clean when not in use
- Slider - slides up over bristles to allow cap to go on
- Brush Head - powder dispenses through the middle
- Brush Body - powder flows from the powder reservoir to the brush head through this section
- Powder Reservoir - stores the powder, but also a partial twist of this area puts the brush in the “open” position
- Bottom Cap - twist-off cap keeps the powder contained. Only remove to refill the powder reservoir.
Directions
When you receive your brush, it will be in the “close” position. Do not twist the very bottom of the brush (below the “window” that you can see the powder through) or your powder will spill! To “open” your brush, twist the portion of the brush that says SPF 30 to the left. When it stops, the brush is “open.” Remove the brush cap and slide the protective sleeve all the way down to uncover the brush bristles.
Hold the brush in your hand and flick your wrist until you see a spot of powder on the tips of the bristles. Apply liberally to face, neck, arms and hands, buffing in a circular motion for at least 15 seconds per small area.
When you are finished, turn the powder cartridge back to the right to “close” the brush, slide up the sleeve over the bristles and replace the brush cap.